How cooperation works:
1. Initial appointment
Obtaining the requirements.
2. Analysis
Analysis of customer needs.
3. Solution proposal
Desing of the technology and equipment.
4. Delivery
Manufacturing, assembly, commissioning, handover, service.
Automatic pass-through powder coating line. The surface preparation line is designed as a continuous spraying machine using the technology of combined degreasing and Fe-phosphating. Chemical concentrations in the degreasing bath are maintained automatically by pH measurement and dosing pumps. The water dryer after surface pretreatment is passable with direct heating of the drying air. The Nordson powder spray booth with cyclone powder paint separation and end filter is made of plastic sandwich panels that allow for a quick color change. Spray guns with HDLV technology are used for automatic and manual application of powder paint. This technology makes it possible to apply the same amount of powder paint over and over again. The curing of powder paints is carried out in a continuous A-shape curing oven with indirect heating. After curing the powder paints, free cooling of hot products follows. All units of the powder coating line are connected by a single-track overhead conveyor, which is used for the transport of parts. In the entire powder coating line, the recovery of residual waste heat is used to the maximum, which is used to heat the supply air via the supply air handling unit. The entire powder coating plant complex is controlled by a control system supplemented by visualization of the technological process and archiving of operational data.
